|
|
 CARING FOR YOUR STRIKEMASTER AUGER
I like to cut holes, lots of holes. That’s why I use a StrikeMaster and have for many years. Every year before ice, I get my gear out and get it ready. I check the rope and make sure it is working easily.
Make sure you have new gas and oil in two strokes. Use fresh gas in four strokes, also change oil in four strokes if it is one year old. Check spark plugs and carry spares with you.
Ok, now the Auger and cutting blades: they have to be razor sharp,to do the best job. Carry new blades with you. There are times when you cut into sand or dust on the ice and it will dull them fast.
NOW THIS IS VERY IMPORTANT
If you are having trouble with the blades icing up at very cold temperatures 0-30 below, DO THIS: Check the little screws that hold your blades on and file them flush with the blades, be very careful not to touch cutting edge with the file. Ice will not stick to a flat surface as easily.
When it is below zero water freezes instantly, so when you cut through and water comes up the hole, keep the auger spinning as you pull it out. DON’T set it in the snow with water on the blades. Let it spin the water off. Maybe spin it on the ice like you were going to cut another hole.You’ll have a lot less trouble this winter on those super cold days.
P.S. Remember, you long armed guys don’t pull the rope out of the auger. Short strokes are best for starting.
Always take a spare StrikeMaster with you, if you are going to Canada, as you know anything that is man made can break, especially in very cold weather.
Good Luck Fishing
Gary Roach “Mr. Walleye”
|
|
